*
o
+ This is purely a temporary measure and NOT a permanent solution. It may last indefinately, but, if it's just to get

important video footage off it then, do so and discard it. It's a lot cheaper to buy a new tape then to have your video repaired !

It's quite easy, but try not to handle the magnetic or(dull) side too much.

If you are uncertain about tackling it, watch the 'How to... DIY' series on 'Youtube' --'Splicing a music cassette'. Basically, the same applies.

To release the tape from the spools place the cassette on the table with the underside facing up. Release the spool sprocket spring lock through the bottom hole between the spools - only light pressure is needed. (You could tape something in there to give you two hands.) Now release the little flap spring lock at the side & lift the front flap to pull enough tape from either spool through either side of each guide roller to work comfortably. If the broken ends are inside the cassette then you will have to dismantle the cassette carefully and draw the ends over the guide rollers, replace the half and secure.

Answered by Santosh Kuma , an ibibo Master, at 6:04 PM on February 03, 2009