How to use HyperTerminal:(Hacking)  

HyperTerminal is a small program that comes with Microsoft Windows. You can use it to send AT commands to your mobile phone or GSM/GPRS modem. It can be found at Start - Programs - Accessories - Communications - HyperTerminal. If you cannot find it and you are using Windows 98, then probably you have not installed it. You can go to Control Panel - Add/Remove Programs - Windows Setup tab - Communications list box item - Details button to install MS HyperTerminal. Before you start programming your SMS application, you may want to check if your mobile phone, GSM/GPRS modem and SIM card are working properly first. The MS HyperTerminal is a handy tool when it comes to testing your GSM devices. It is a good idea to test your GSM devices beforehand. When a problem occurs, sometimes it is difficult to tell what causes the problem. The cause can be your program, the GSM device or the SIM card. If you test your GSM device and SIM card with MS HyperTerminal and they operate properly, then it is very likely that the problem is caused by your program. For Linux users, minicom can be used instead of HyperTerminal. For more details visit the following link : 1) http://www.developershome.com/sms/h owToUseHyperTerminal.asp 2) http://www.stepperboard.com/using_w indows_hyperterminal.htm

Answered by Pammu at 3:18 PM on November 12, 2007

HyperTerminal allows you to open a "server" on any port of your computer to listen for incoming information from specified computers. To use this, go to StartProgramsAccessoriesCommunic ationsHyperTerminal. First you will need to select the connection, pick "TCP/IP Winsock", and then put in the computer to communicate with, and the port #. You can tell it to listen for input by going to CallWait for Call. Now the other computer can connect to you on that port, and you can chat and transfer files.

Answered by alokgupta14 at 3:16 PM on November 12, 2007